Fu10 Day Watching 18 Install 【2027】

Set gain to 0-6dB (no higher, or noise appears). Iris should be manual: F5.6 to F8.0 for deep depth of field.

Run a shielded Cat6 cable (max 100m) for power over Ethernet (PoE) plus a separate BNC for analog fallback. Avoid running parallel to AC power lines. Phase 2: Power-On & Network (Steps 5-8) Step 5: Initial Boot Connect power. The FU10 will take ~45 seconds to initialize. Watch for the green LED (steady = good; flashing = SD card error). fu10 day watching 18 install

Via the on-screen display (OSD), set a static IP (e.g., 192.168.1.100). Disable DHCP to prevent address changes mid-installation. Set gain to 0-6dB (no higher, or noise appears)

Related Products

Scara Robot

The ERS SCARA can be centrally managed by the nutrunner which controls the robot. This robot is easy to setup and program.

Tracer Arm

This assist arm eliminates the reaction force on the operator. The position detection system prevents mistakes such as skipped fasteners, wrong part tightening, and incorrect tightening procedures.

Corded Tools

Corded handheld nutrunners. We have various tools in our lineup, from 1 to 600 N･m ( 0.7 to 442.5 ft･lb ). A single controller can be used for a wide range of torques.

Cordless Tools

Cordless handheld nutrunner. High operator maneuverability without cables. Best for congested work areas.