Big — Shot Install

Pull the loose, long end of the band through the small loop you just pushed through the hole. Pull tight. This creates a "slip knot" or "girth hitch" around the fork post. For a big shot install, you must ensure the knot cinches flush against the frame—not protruding outward.

Cut your latex tubes to your desired active length (usually measured from the fork to your anchor point). For a standard adult, 10 to 12 inches of active latex is a good start. Melt the cut ends with a lighter to prevent fraying. big shot install

Repeat the process on the other side. Align the pouch so it hangs perfectly straight. If the pouch cants to the left or right, you will shoot unpredictably. The Golden Rule: Symmetry Regardless of which method you choose for your big shot install, symmetry is king . Measure the length of latex from fork to pouch on both sides. A difference of just 2 millimeters will cause the projectile to curve left or right (known as "shooting around the fork"). Pull the loose, long end of the band

Cut two slits in the leather pouch (if not pre-cut). Insert the free ends of your bands through the slits from the back. Fold the band tips over and tie them with floss. Again, use the lighter to melt the folded tip into a "mushroom" so it cannot pull back through the slit. Method 2: The Clip-On (Flip Clip) Install Modern Big Shot frames often feature recessed clamps or "Flip Clips." This is the easiest big shot install for beginners. For a big shot install, you must ensure

Replace the flip clip over the band. Tighten the screws evenly. Do not overtighten—you want to compress the latex, not shear it. The latex should bulge slightly out the sides but not be cut by the metal edge.