In Bioprocess Development - A Mab A Case Study

High turbidity in the load causes column fouling and pressure spikes >3 bar.

Lowering the pH during harvest. As the culture ages, CO2 builds up, lowering pH to 6.7. Mab-X has a unique hydrophobic patch in the Fc region that is prone to unfolding at pH <6.8. A Mab A Case Study In Bioprocess Development

The remaining HCPs and DNA carry a negative charge at pH 8.0. Mab-X, with a pI of 8.5, flows through a Q Sepharose FF column. This step reduces HCP to <30 ppm and DNA to <1 pg/mg. Part 4: Formulation and Drug Substance – The Final Barriers The purified Mab-X is now in a low-pH, high-salt buffer unsuitable for injection. The case study addresses two final challenges: 4.1 Concentration and Diafiltration Using tangential flow filtration (TFF) with 30 kDa cassettes, the team concentrates Mab-X from 2 mg/mL to 120 mg/mL. Viscosity becomes the enemy. At 100 mg/mL, viscosity reaches 25 cP, causing high pump shear and membrane fouling. High turbidity in the load causes column fouling

Depth filtration (3.0 µm to 0.2 µm) followed by a 0.1 µm pre-filter. The team also introduces a low-pH hold step (pH 3.7 for 60 minutes) before loading to precipitate some HCPs, which are then removed by a second depth filter. Mab-X has a unique hydrophobic patch in the

Introduction In the biopharmaceutical industry, the term "A Mab" (Monoclonal Antibody) has become synonymous with the modern era of targeted therapeutics. With over 100 Mabs approved by the FDA and a global market exceeding $200 billion, these large, complex proteins have revolutionized the treatment of cancers, autoimmune diseases, and infectious diseases. However, the journey from a hybridoma cell line to a commercially viable drug product is a gauntlet of scientific and engineering challenges.